Bodet Profil 960 Instruções de Operação

ClockProfil 960For in do or or out do or mo delsINSTALLATION AND OPERATING INSTRUCTIONSWhen receiving goods please chek nothing is broken otherwis

3.5. Independent Quartz clock on mains :Single Face.– Connect mains supply (230VAC) to the terminal (20) of thepower supply unit (ref.933006).– Connec

3.7. Lighting connectionA 10 A fuse or circuit breaker for thelighting power supply should beinstalled and switched off prior to anymaintenance in the

IV - OPERATING AND TIME SETTINGNOTA : to respect the security rules, the time distribution network must be be SELV-type.- The impulses wires should be

4.1.2. ½ minute and minute serial receiver,- Connect the time distribution network toterminals 1 and 2 on the terminal strip (3).- The terminal 3 of t

4.2. AFNOR/IRIG-B time signal receptionOperating principle of AFNOR HM receiver clock :During 1 hour without reception of the time signal the clock op

4.3. France Inter radio receiver clockAntenna connection :Connect the 2 wires of the antenna on the FI andGND terminal.Caution: to avoid interferenc

4.5. Independent Quartz on mains with remote keyboardSee the booklet of the remote keyboard, reference : 605198.Attention : in case of a double face c

V - TECHNICAL FEATURESReadability : 60m.Dimensions :Profil 960 Indoor Profil 960 OutdoorProfil 960 Double face Indoor Double Face integrated Outdoor

France Inter radio receiver clock with synchronous second hand :Permanent power supply : 230V; 70mA.Accuracy : absolute with automatic summer/winter

Supply OperatingtemperaturesProtection indexWeightProfil 960 I HM minute// and ½ minute serialreceiver-10°C to +50°C IP401 6,5 kgProfil 960E HM minute

Table of contents I - INITIAL VERIFICATION ...3 1.1 Un pack ing the clock ...31.2 Clean ing ...

VI - WHAT TO DO IF...? ...CHECK.What to do if...? … Check.– The clock (powered by battery)had stopped.– The battery has run out. Replace the batter

ENGLISHI - INITIAL VERIFICATIONThank you for choosing a BODET clock. This product has been carefully designed for yoursatisfaction based on ISO9001 qu

impulses on a serial ligne ; it is powered by 240 VAC, with a servo second hand.REC MN 1V5 = the clock is a receiver driven by a control unit “Remote

2.2 Single Face outdoor clock- Open the clock by giving the 2 screws (3) aquarter turn with the key (1), and then pull thewhole dial towards you (hing

2.3.1. Double Face integrated clockDrill the support (wall, pillar, ...) to therequired dimensions and fix the bracket.- Unscrew by 10 mm the 2 bolts

2.3.2 Clock on keyboard- Drill the support (wall, pillar, ...) to therequired dimensions and then fix thebracket.- If necessary, carry out the various

III - POWER SUPPLYInstallation and maintenance of this equipment must be carried out by qualified personnelonly.Electrical installation must comply wi

3.3. AFNOR HM clock low voltage 6/24VConnect the low voltage (TBT) power supply (6 to 24V AC or DC) to the connectors 1 and 2: maximum 1,5 mm2 wire s